Glossary · General construction

Section (Drawing)

Definition

A drawing showing the structure as if sliced vertically, revealing how floors, walls, and roof assemble and stack — used to communicate construction detail.

Source: Wikipedia — Cross Section (Architecture)

  • Setback

    The minimum required distance between a structure and the property line, street, or other features. Setbacks constrain where additions, d…

  • Sealant

    A material applied to a surface or joint to block the passage of water, air, or stains. Stone counters, grout, and exterior penetrations…

  • Sheathing

    The structural panel layer (plywood or OSB) attached to studs or rafters that braces the frame and provides a base for siding, roofing, o…

  • Scope of Work

    The detailed written description of exactly what the contractor will and will not do on the project. The single most important document f…

  • Slab

    A poured concrete floor or foundation surface. Moving plumbing in a slab-on-grade home means saw-cutting and patching concrete — a signif…

  • Scaffold

    A temporary elevated work platform system. Proper scaffolding is a regulated safety item on multi-story exterior and high-ceiling interio…

  • Stop-Work Order

    An official order halting construction, usually for working without a permit or a code/safety violation. Work cannot resume until the iss…

  • Rough-In

    The stage where plumbing, electrical, and HVAC lines are run inside open walls and floors before insulation and drywall. Rough-in must pa…

Ready to Start Your Project?

Get a free estimate based on real Columbus contractor pricing.

Start Estimating → Read the bath guides